CE-4001 & CE-6001 - This end cap is designed as a secondary stop. Installed at the extremity of the rail, it closes the rail and prevents objects from falling. It is adaptable to both 4" and 6" rails.

CE-4002 & CE-6002 - This end cap is designed to absorb the force of impact caused by the striking of the end cap by loads of 2500 inch-lb/cycle for the 4" rail and 5400 inch-lb/cycle for the 6" rail. It greatly reduces the noise and vibration normally caused by abrupt load stops.

CE-4003 & CE-6003 - The mid rail end stop with shock absorber can be used to limit movement at any point on the system of a continuous rail. It absorbs the force of impact caused by the striking of the end cap by loads of up to 5400 inch-lb./cycle. It greatly reduces the noise and vibration normally caused by abrupt load stops. It is adaptable to both 4" and 6" rails.

CE-4004 & CE-6004 - The mid rail end stop can be used to limit movement at any point on the system of a continuous rail. It is adaptable to both 4" and 6" rails.

PR-4000 & PR-6002 - This gate allows easy access to change and remove parts from an continous rail lenght. It make easier maintenance within the rail.

M-5002 - The tractor allows for the moving of accessories along the rails. The speed and distance can be ajusted. This tractor is easy to install. It can be installed on many different types of rails and beams. It must be installed with a air filter and lubricant. It is important to limit the air pressure to the wheel cylinder to 60 psi to avoid any damage to the motor.

MB-1200 & MB-1600 - Used in the creation of manipulators, it allows a 360° rotation. Available in 12" and 16" formats.